ME home
 
  SME FaceBook SME Twitter SME LinkedIn RSS Feed

Subscriber or
SME Member Log On

WEB-ONLY CONTENT

Go to SME eNEWS

MINING INDUSTRY EVENTS

George Fox Conference  - Conference
Jan 24, 2018
2018 SME Annual Conference & Expo  - Conference
Feb 25, 2018 - Feb 28, 2018
Mongolia Mining 2018  - Conference
Apr 4, 2018 - Apr 6, 2018
USA Pavilion at Expomin 2018  - Exhibit
Apr 23, 2018 - Apr 27, 2018

METAL PRICES


Au
Ag
Pt
Pd
Ni
Cu
Al
Pb

AGGREGATES
AND MINERALS
MARKETPLACE


http://aggregatesmineralsmarketplace.com
The Mining Engineering, SME and NSSGA
Online Buyers Directory Site
The Online Global Mining and Minerals Library Site
February 2015
Volume 67    Issue 2

Evaluations of bit sleeve and twisted-body bit designs for controlling roof bolter dust

Mining Engineering, 2015, Vol. 67, No. 2, pp. 34-40
Beck, T.W.


ABSTRACT:

Drilling into coal mine roof strata to install roof bolts has the potential to release substantial quantities of respirable dust. Due to the proximity of drill holes to the breathing zone of roof bolting personnel, dust escaping the holes and avoiding capture by the dust collection system pose a potential respiratory health risk. Controls are available to complement the typical dry vacuum collection system and minimize harmful exposures during the initial phase of drilling. This paper examines the use of a bit sleeve in combination with a dusthog-type bit to improve dust extraction during the critical initial phase of drilling. A twistedbody drill bit is also evaluated to determine the quantity of dust liberated in comparison with the dust-hog-type bit. Based on the results of our laboratory tests, the bit sleeve may reduce dust emissions by one-half during the initial phase of drilling before the drill bit is fully enclosed by the drill hole. Because collaring is responsible for the largest dust liberations, overall dust emission can also be substantially reduced. The use of a twistedbody bit has minimal improvement on dust capture compared with the commonly used dust-hog-type bit.



Please login to access this article.

OR

If you are not an SME member, you can join SME by clicking the button below.